Spreading of colors

1. Select any layer.
   
2. Activate tool Smudge (Finger), pushing key R or Shift+R
   

   On the panel of options (fig. 12.39,12.40) on an arrow in the field Brush (Paintbrush) also select paintbrush type on the pop-up panel.
   

3. Select value in the field Mode (a mixing Mode) («mixing Modes» see chapter 2, section). Set mode Normal (Normal) to spread all color hues, Darken to (Black out) to add dark colors in more light, or Lighten to (Clarify) to admit light colors in more dark. Move slider Pressure (Pressure) upon value below 100 %.
   
4. At will. On the panel of options deliver flag Use All Lauers (to Use all layers) to spread colors from all visible layers of the image (at a choice of this option remove flag Finger Painting (Drawing by a finger)). Remove flag Use All Layers (to Use all layers) to spread color only from the active layer. Anyway, of course, will be changed пикселы only the active layer.
   
5. At will. To begin process of spreading with primary color, on the panel of options deliver flag Finger Painting (Drawing by a finger). If this option is disconnected, spreading begins with color of that point in which the dash begins. The above value of parameter Strength (Pressure), the more primary color will be applied.
   

   Push ALT key temporarily to include option Finger painting (Drawing by a finger) if this flag is removed.
   

6. Drag the cursor through any area of the image (fig. 12.41-12.44). If it is necessary, make a pause that the program had time to reflect the made changes in the screen (an arrow the direction of driving of the cursor) is designated.
   

Fig. 12.41. The Source image

Fig. 12.42. Result of application of tool Smudge in mode Normal

Fig. 12.43. Result of application of tool Smudge in mode Darken

Fig. 12.44. Result of application of tool Smudge in mode Lighten